A culture of care, reliability and safety.

TransQuip’s Industrial Aluminium Loading Ramps

Posted 6th February 2020
Ramp Range 7.3.17_Final-1

Watch the video below to see our large range of alloy ramps from small mower ramps up to large machinery ramps. 

Check out our range of Alloy Loading Ramps

Benefits and Features of our Aluminium Loading Ramps:

  • Lightweight alloy you can lift safely, with much less strain on your back
  • Can be stored in or outside and they won't rust
  • The aluminium extrusion they use has been specifically designed for purpose. The extrusion they use is not “off-the-shelf.”
  • One of the few high capacity loading ramps in New Zealand
  • The bulkhead (the end that rests on the deck) has been designed with two “gripping teeth” (circled in image below) that have two functional purposes;
    1. Allows the head of the deck pins to not protrude and be exposed to damage from tracks
    2. Adds extra grip at the top of the ramps so the ramps don't slip off the deck while loading
  • If these sizes don't suit customised options are available

 

Did you know?

  • The 6T and 7.5T come as left and right hand? A section of the bulk head is removed to allow the ramps to be pushed to the most outer point of the bin to allow for the overall width of the wider track width on the larger machines. If a customer loses or damages a ramp; need to know which side and serial number.
  • 20 degrees is the “safe zone” for the travel angle of ramps. What the machine runs on (tracks, wheels etc) also plays a factor. The likes of a tractor may be able to travel up a steeper angle than 20 degrees

 

Points to be considered when working out what ramps will work best for you:

  1. The total weight of your machine
  2. The track or tyre width
  3. The height of truck/trailer deck from ground
  4. What an acceptable gradient for your machine is